Ford Cortina V8

01 March 2014 Car Specifications 1397

Here we have a 1967 Series 1 Mk2 Ford Cortina Deluxe, 4 door in Sea Foam Blue and very little interior. This car has not been finished but it is getting there.

The car is being build for drag strip action and if all goes well will also be used on the public highway!! This project car has been built practicably from scratch.

Modifications

  • Engine
  • Gearbox
  • The Rest
  • Roll Cage Video
  • Mopar 318 cu in (5.2 litre) V8 engine.
  • Eldebrock Performer inlet manifold, Holley 600 sec vac carb with Edelbrock 14" Air Filter.
  • Pertronix Ignitor electronic ignition with their 40,000 volt Flame Thrower coil.
  • Remote oil filter.
  • Speedflow hoses and JIC fittings.
  • Patriot Tight Tuck Headers from Pertronix.
  • 75amp alternator.
  • Small lorry battery.
  • Plymouth Radiator upgraded from 2 to 3 core.
  • 16" electric fan with an adjustable thermostat.

Full-Manual Competition Transmission

Designed for the extreme high performance street or all out race car, the TCI Automotive Torqueflite 904 Full Manual Competition Transmissions will give you consistent shifts as well as complete control over shift points. Reverse shift pattern, they require no vacuum hookups or kickdown linkage. This means there are no external linkages to be purchased, which saves some expense. The increased line pressure provides a harder, quicker shift and eliminates the lag time between shifts produced by automatic shift transmissions.
  • Extreme Performance Clutches & Nitrided Steel Plates for Enhanced Performance
  • High-Performance Powerbands Provide Greater Torque Capacity & More Positive Shifts & Band Apply
  • Hardened Sprag Races Increases Durability & Strength
  • Improved Lubrication System Increases Fluid Sent to Planetaries & Internals
  • Able to Handle Up-to-750HP
  • Lokar billet remote dipstick/filler
  • B&M Mega shifter.
Currently on route from the USA.
  • Space frame chassis.
  • 8 point Roll Cage tied into chassis (Rollcage built by Huxley Motorsport)
  • Jaguar Series 2 IRS with inboard disc brakes. Narrowed 6.5" each end and a 3.77 Power Lok (LSD) diff.
  • Mk4/5 Ford Cortina IFS, steering rack with Princess 4 pot calipers, 285mm vented discs and Green Stuff pads.
  • Custom made one picece halfshafts - 2.5" diameter.
  • Custom made single piece propshaft.
  • GAZ adjustable shocks with GAZ 350lb custom made front coil springs.
  • GAZ adjustable coil overs with 400lb springs on rear.
  • Front suspension, anti-roll bar fully polypushed.
  • Custom made 2.5" stainless exhaust systemt incorporating a cross over pipe and polished silencers.
  • 8 fuse wiring module kit.
  • Dooms day ignition switch, warning light and push button starter.
  • Positive and Negative 4awg cable, Gold plated battery terminals, earthing point and starter motor connector.
  • Auto Meter Pro-Comp Ultra-Lite Series guages. The small gauges (52mm) are Water Temperature, Fuel, Oil Pressure and Voltmeter. The larger 5" guages are the 10,000rpm Memory Tachometer and the 160mph Electronic speedometer.
  • Wilwood brake proportioning valve.
  • Compact Willwood master cylinder.
  • Shift light for tacho.
  • Shift light for electric line loc activation and electric line loc.
  • Momentary switches fitted on custom made aluminium steering wheel bracket.
  • Hydraulic flyoff handbrake.
  • Custom laser cut FIA towing eye.
  • Monaco S bucket seats.
  • Jaz Pro Street fuel cell.
  • Fram HGP1 fuel filter 602 and Holley Red Top fuel pump.
  • 6"x15" alloys with 195/45 x15 tyres on front with 8"x15" alloys and 225/50x15 on rear.
  • Custom made removeable front end all in fibreglass.
  • Fibreglass rear valance and strengthened boot lid.
  • All new floor, firewall front and rear, tubs and gearbox/propshaft tunnel.
Last modified on Monday, 19 November 2018 16:38